I'm having a problem getting Xamp Lite working on my USB flash drive. The installation completes without any errors but whenever I try to start Apache the Xamp control panel shows it as running and then stops again.
I get the following error when I run the 'apache_start' batch file:
- Code: Select all
Diese Eingabeforderung nicht waehrend des Running beenden
Bitte erst bei einem gewollten Shutdown schliessen
Please close this command only for Shutdown
Apache 2 is starting ...
apache.exe: Syntax error on line 477 of E:/xamp/apache/conf/httpd.conf: Syntax error on line 7 of E:/xamp/apache/conf/extra/httpd-xampp.conf: Cannot load E:/xamp/apache/bin/ph
p5apache2_2.dll into server: The specified module could not be found.
Apache konnte nicht gestartet werden
Apache could not be started
Press any key to continue . . .
I did a quick search on this earlier and saw one suggestion was to make sure .net Framework 1.1 was installed. I've since done this and I'm still getting the same error. Any other suggestions?
Thanks!