Stefy71 wrote:Maybe it's strange for you but I'm not a technical programmer, I'm a graphic designer. So I never used terminal, commands, threads... I downloaded the package of PCRE-8.38 but there are a lot of files inside (???) where do I have to put this folder?
Put it where you like, that does not matter. Unpack, if it is packed.
Stefy71 wrote:Do I open the terminal.app of my MAC and then?
Yes, open a terminal. Then you should remember the name of the folder, where you put the files from above. Lets say its /User/Stefi71/pcre-8.38 (or similar, you should see that in the file explorer). Type the following command into the terminal:
- Code: Select all
cd /User/Stefi71/pcre-8.38
and hit enter. Of course, you must apply the correct folder name above.
When you made an error, you will receive an error like "no such file" or something like that. Then try again, if you dont get it, show us here, what you did. We will find out, what is going wrong.
Then you enter the three commands from the other thread, you may simply copy them from here:
- Code: Select all
./configure --prefix=/Applications/XAMPP/xamppfiles --enable-utf8 --enable-unicode-properties
and then
- Code: Select all
make
and finally
- Code: Select all
sudo make install
The last command will prompt for a password, simply enter your own password. And now you are done. You will see lots of output after each line (always hit Enter for each line and wait and see). If nothing goes wrong, you now start Xampp again and try to continue WordPress Installation.